INERTIAL MEASUREMENT PRODUCTS

ATTITUDE WITH GPS-AIDED HEADING

DMS-SGP01

The DMS-SGP01 provides attitude and heading outputs. It uses a single antenna GPS system for a heading reference that can provide track heading during GPS outages or while stationary.
View Specs » Manual »

DMS-EGP01

The DMS-EGP01 is a higher accuracy single antenna GPS enabled AHRS. It uses gyros with lower bias and noise characteristics for more accurate attitude outputs.
View Specs » Manual »

DMS-SGP02

The DMS-SGP02 is equipped with a dual antenna GPS system, so it provides a GPS heading reference signal even while the unit is stationary.
View Specs » Manual »

DMS-EGP02

The DMS-EGP02 has precision gyros along with our dual antenna GPS heading reference system. This makes the inertial measurement unit a fully static and dynamic capable Attitude and Heading Reference System (AHRS) while receiving GPS data.
View Specs » Manual »

INERTIAL MEASUREMENT

DMS-S605

This inertial measurement sensor provides bank and elevation attitude output along with leveled accelerometer outputs in a small hard-mountable housing.
View Specs » Manual »

DMS-E604

With the same outputs as the DMS-S605, this model uses larger, more accurate and stable gyros for more precise signals.
View Specs » Manual »

TRAIN MEASUREMENT

TMS-E232

Equipped with an extensive sensor suite, this inertial gyro sensor also has the durability required by the rail industry. The TMS-E232 can measure roll rate, yaw rate, superelevation, and truck hunting.
View Specs » Manual »